The newly designed Electric RC Helicopter – Raptor E620 SE. The Raptor-E Series are based on a proven design the original Thunder Tiger Raptor Nitro Series.
Specification:
Full Length of fuselage: 1220mm (48.03")
Full width of fuselage: 140mm (5.51")
Total height: 390mm (15.35")
Main rotor dia: 1345~1385mm (52.95~54.53")
Tail rotor dia: 237mm (9.33")
Gear ratio: 1:8.54~12.33:4.56
Full equipped weight: 3,500g (7.7 lbs)
Thunder Tiger equipped the Raptor E620 SE with E-CCPM (Electronic Cyclic/Collective Pitch Mixing) control system. Reliable flying characteristics, optimize frame structure with higher center of gravity make for more lively control response. The Thunder Tiger Raptor E620 SE – the best 3D electric RC helicopter, to enjoy the extreme 3D flying.
The Thunder Tiger Raptor 50 SE (Nitro Series) metal rotor head and Raptor 50 Titan's longer type tail drive system. It is combined with carbon lower side frames, designed to adopt the electric power unit and provide the best power-to-weight ratio.
Features:
- Reliable Raptor 50 SE rotor head and Raptor 50 Titan longer tail drive system
- Push-Pull linkage for control surface
- 90° E-CCPM control system (Optional – 140° E-CCPM)
- Carbon lower side frame
- Carbon Fins
- Easy installation of rear motor mounting system
- Incline battery installation brace
- Optimize gear ratio setting
- New Design Raptor-E Decal Set
Accessories Needed:
- Radio Set - Transmitter (6 or more channels), Servo x4, Receiver, Battery, Switch Harness, Gyro, Foam, Rubber Band.
- Propulsion System - Brushless Motor 6S–(No.2379 OBL 43/11-30 H) - 10S–(No.2380 OBL 49/08-50H), Speed Control 6S–(No.8043 ACE BLC-75) - 10S–(ACE BLC-65), Li-poly battery 6S~10S (Flightpower EVO49006S1P or EVO330010S1P or EVO370010S1P)
- Main Rotor Blades - 620 mm, need to be purchased, example use carbon blades NHP1011 or NHP1011W or 600 mm carbon blades NHP1010 or NHP1010W or 600 mm wood blades PV0118, RCT0056, RCT0127, RCT0127W
|
